DURKOPP ADLER 275 Series Operating Instructions Manual page 29

Operation
Operating Instructions 275 - 02.0 - 08/2019
Fig. 8: Winding the hook thread (2)
③ ④
(3) - Winder tension
(4) - Thread guide
(5) - Bobbin shaft
4. Fit the empty bobbin onto the bobbin shaft (5).
5. Insert the thread from the right to the left through the thread
guide (4).
6. Guide the thread clockwise around the gap in the winder
tension (3).
7. Wind some of the thread clockwise onto the bobbin.
8. Pull the thread through the cutting clamp (6) and cut it off after
this.
9. Press the bobbin winder flap (7) against the bobbin.
10. Switch on the machine.
11. Press the pedal forwards.
 The machine starts sewing and winds on the hook thread in
the process. When the set filling quantity ( Service
Instructions) is reached, then the winding process will stop
automatically..
The hook thread is normally wound on when sewing is in progress.
However, you can also wind on the hook thread without sewing,
e.g. if you require a full bobbin in order to start sewing.
⑤ ⑥
(6) - Cutting clamp
(7) - Bobbin winder flap
⑦
27