Limiting The Upper Transport Length - DURKOPP ADLER 275 Series Operating Instructions Manual

38

4.10.3 Limiting the upper transport length

Certain equipment requires the maximum upper transport length
to be limited to a value less than 8 mm.
The limiter for this is supplied with the corresponding sewing
equipment.
Fig. 19: Limiting the upper transport length
(1) - Limiter
To limit the upper transport length:
1. Complete the assembly of the limiter (1) with washer and
screw.
2. Insert the limiter (1) into the slot and turn by 90°.
3. Slide the limiter (1) to the value on the scale corresponding
to the maximum upper transport length for the sewing equip-
ment being used.
4. Screw the limiter (1) tight at the desired position with the
screw.
Operating Instructions 275 - 02.0 - 08/2019
Operation
①