DURKOPP ADLER 275 Series Operating Instructions Manual page 54

52
Button Function
Sequence buttons 1 to 8
Each of the sequence buttons can be assigned its own
...
upper transport value via the Plus/Minus buttons.
The LEDs above the buttons indicate the following sta-
tes:
• Red LED on = sequence is active
• Both LEDs off = sequence is activated but not cur-
rently being executed
• Green LED on = Sewing sequence currently being
executed
Plus/Minus buttons
These buttons are used to setting the upper transport
length for the respective sequence or for smooth
sewing. Values from 1 to 8 can be set. The upper
transport length can only be a maximum of 1 mm smal-
ler than the stitch length. If the upper transport length is
reduced further then the stitch length is also reduced.
(De-) Activation button
Pressing this button and a sequence button at the
same time switches the corresponding sequence from
active to inactive and vice-versa. The red LED above
the sequence button lights up for inactive sequences
and goes out for active sequences.
Button for automatic direction change
The sequences are normally processed in increasing
order. After the last sequence the controller begins
again with the first sequence. When the button for
automatic direction change is actuated, the sequences
are processed alternately, first in increasing order and
then in decreasing order. The green LED above the
button lights up when this function is active.
F button
This button can be used for enabling the edge cutter
for every sequence and for smooth sewing. The green
LED above the button lights up when the edge cutter is
active.
Display
The display shows the current upper transport length.
The values can lie between 1.0 and 8.0.
In the case of errors the error code is displayed.
Operating Instructions 275 - 02.0 - 08/2019
Programming