92
7.12 Setting the DAC mini multiple width control
Fig. 48: Setting the DAC mini multiple width control
①
②
(1) - Button smooth sewing
(2) - Sequence buttons
(3) - Display
(4) - Plus-/Minus-buttons
Checking the basic settings of the control
After setting up the machine the basic settings of the control must
be checked and adjusted if necessary.
Calling up the special functions
To call up the special functions:
1.
Hold the button
The green LED above the button lights up.
2.
Release the button
The green LED above the F (6) button flashes.
After the internal system test has completed, the display (3)
shows the Special functions selection:
The various special functions are called up by pressing the se-
quence buttons (2) with the numbers 1 to 7. The green LEDs above
the buttons indicate the respective function that has been called
up.
The following sections describes the special functions of buttons
2, 4 and 5. The other special functions are described in the
Service Instructions.
③
④ ⑤
(5) - Activation/Deactivation button
(6) - Button F (Enable/Function)
(7) - Direction change button
pressed and switch on the machine.
.
Operating Instructions 275 - 02.0 - 08/2019
Setup
⑥
⑦