Machines With Dac Mini - DURKOPP ADLER 275 Series Operating Instructions Manual

Setup
Operating Instructions 275 - 02.0 - 08/2019
5. Hang the pedal rod (4) with the ball socket on the setpoint
device (2) and attach to the pedal (5).
6. Pull the pedal rod (4) to the correct length.
Proper setting
The pedal is correctly adjusted if it has an inclination of 10° when
released.
7. Tighten the screw (3).
7.6.2

Machines with DAC mini

On machines with DAC mini the setpoint device is installed at a
different position.
Important
With this subclass a large number of assemblies are fitted under
the tabletop.
For this reason it is essential to observe the dimensional diagram
of the tabletop ( p. 77).
Fig. 43: Machines with DAC mini
(1) - Angle
To assemble the pedal and the setpoint device:
1. Screw the angle bracket under the tabletop at the position
shown in the diagram.
2. Screw the setpoint device onto the angle (1).
3. Install the pedal in the same manner as with a machine without
a DAC mini ( p. 84).
①
85