6 Operation
6.3 Configuration of the Device
I/O Mirror Client
NOTE
Can only be parameterized, if no I/O mirror mode is selected under Communication Serial.
Figure 6-34
✧
Enter the server IP address into the Server IP address field.
✧
Enter the port number (≥ 10000) into the Server port field.
✧
Enter the response time under Response timeout.
Siemens recommends the factory setting.
✧
Click the Send button.
After clicking the Send button, the parameters are transmitted to the device but not enabled yet (passive
parameter set).
✧
If you do not want to change any other settings, continue with the Activation of the device configuration
according to chapter 6.3.1.3. If you want to change other settings, enter the changes and then enable the
device configuration.
86
Configure Tab, Communication Ethernet via I/O mirror Client Input/Output Window
SICAM I/O Unit, 7XV5673, Device Manual
E50417-H1040-C484-A3, Edition 05.2012