Siemens 7XV5673 Device Manual page 76

6 Operation
6.3 Configuration of the Device
6.3.3.4 Indication Properties
When setting up the indication properties, you will decide which entries are to appear in the operational log
(indication logging).
Table 6-5
Parameter
Indication x from Remote
(x = 1 to 6)
Binary Output y - Terminal
Block z
(y = 1 to 3, z = N or P)
Binary Input y - Terminal
Block z
(y = 1 to 3, z = N or P)
To change the indication properties, proceed as follows:
✧
In the navigation window, select the Operational menu, then the Administrative submenu and click
Indication properties.
The Indication properties input/output window opens.
Figure 6-30
76
Indication Properties Settings
Default Setting
Not configured
Not configured
Not configured
Configure Tab, Indication Properties Input/Output Window
Settings
Not configured
On
Off
On/Off
Not configured
On
Off
On/Off
Not configured
On
Off
On/Off
SICAM I/O Unit, 7XV5673, Device Manual
E50417-H1040-C484-A3, Edition 05.2012