Siemens 7XV5673 Device Manual page 209

Indication
(Relevant for Operating Mode)
Settings Check
Settings Activate
Indication x from Remote
Binary input x - Terminal block N
Binary input x - Terminal block P
I/O Ethernet OK
(Ethernet I/O mirror
(server or client) and
Modbus UDP server)
SICAM I/O Unit, 7XV5673, Device Manual
E50417-H1040-C484-A3, Edition 05.2012
Description
The passive parameter set is to
be activated; the internal
parameter check is running.
The passive parameter set is
enabled and the device works
with these parameters.
x = 1 to 6
Status of the indications that can
be set to control the LEDs and the
relay outputs via the communica-
tion
x = 1 to 3
Terminal block N
x = 1 to 3
Terminal block P
Client mode:
ON: The connected server replied within the response timeout (but not with a
Modbus Exception Response).
OFF: The connected server has not replied to the request of the client or replied
with the Modbus Exception Response.
Server mode:
ON: At least one valid Modbus UDP telegram was received (which does not lead
to a Modbus Exception Response.)
OFF: No Modbus UDP telegram was received within the set monitoring time.
12 Operational Indications
Notes
Indication on: Check started
Indication off: Check complete
Indication on: Activation started
Indication off: Activation complete
Indication on: ON
Indication off: OFF
Message invalid: Not yet updated via the
communication or again invalid via the
communication
-
-
209