Siemens 7XV5673 Device Manual page 74

6 Operation
6.3 Configuration of the Device
Behavior when Activating the Parameter Set after the Parameter Set was Changed
Persistent:
The binary output is set to the new status (ON or OFF) as defined by the current indication.
Pulse:
If the binary output is ON in pulse mode while activating the parameter set, the binary output is immediately
switched to the OFF status after the parameter set has been successfully activated. This happens even if the
parameterized Output time for pulse operating mode has not yet elapsed.
6.3.3.3 LEDs
Table 6-4 LED Settings
RUN
ERROR
H1
H2
To change the outputs of the LEDs H1, H2 and ERROR, proceed as follows:
✧
In the navigation window, select the Operational menu, then the Process connections submenu and
click LEDs.
The LEDs input/output window opens.
Figure 6-28
74
LED Default Setting
Device ready
-none-
-none-
-none-
Configure Tab, LEDs Input/Output Window
Settings
Not settable
Acc. to list box
(see chapter 13.1.3)
Acc. to list box
(see chapter 13.1.3)
Acc. to list box
(see chapter 13.1.3)
SICAM I/O Unit, 7XV5673, Device Manual
E50417-H1040-C484-A3, Edition 05.2012