System Requirements; Access Rights - Siemens 7XV5673 Device Manual

4 Getting Started

4.4 System Requirements

Terminals for supply voltage (H), binary inputs; and relay outputs (N, P) on the terminal side:
Conductor cross-section, rigid max.
Conductor cross-section with ferrule
Tightening torque
Communication Interfaces
RS485 interface (J) on the terminal side:
820 nm fiber-optic interface (J) on the terminal side:
DANGER
Danger due Laser radiation! Class 1
Non-observance will lead to death or serious injury.
✧
Do not look into the fiber-optic elements!
Ethernet interface (Z) on top:
4.4 System Requirements
To operate SICAM I/O Unit with a PC or notebook, the following system requirements must be met:
• PC or notebook with Intel Pentium processor (or compatible type); clock frequency min. 800 MHz
• Operating system: Microsoft Windows XP Professional with Internet Explorer 6.0 (or higher)
• Minimum 1 GB RAM primary storage
• VGA display 1024 x 768 with truecolor
• Mouse and keyboard
4.5

Access Rights

Access Rights for Configuration and Maintenance
Access rights are controlled by setting up passwords during the device configuration. For this purpose, you
have to assign an activation password and a maintenance password. The setting up of passwords is described
in chapter 6.3.3.9.
If parameter changes are to be activated in the device, the activation password is required. If changes are to
be made in the device via the maintenance tab, the maintenance password is required.
NOTE
If you do not set up new passwords, the passwords automatically implemented by default (see chapter 6.3.3.9)
will be valid.
30
2.5 mm² (AWG 14)
1.5 mm² (AWG 16)
0.4 Nm to 0.5 Nm (3.5 in-lb to 4.5 in-lb)
RS485 cable with plug connector
Fiber-optic cable with prepared ST plug (for example
6XV8100)
Patch cable, crossover cable, or a Y cable, when using
the internal Ethernet switches
SICAM I/O Unit, 7XV5673, Device Manual
E50417-H1040-C484-A3, Edition 05.2012