Devserv Paths Command; Devserv Qpav Commands - HPE XP7 User Manual

The following figure shows a sample output of this command for a Super PAV base device with 192
aliases.
D M=DEV(1580)
IEE174I 11.44.36 DISPLAY M 870
DEVICE 01580 STATUS=ONLINE
CHP 76 77 78 79 86 87 88 89
ENTRY LINK ADDRESS .. .. .. .. .. .. .. ..
DEST LINK ADDRESS 0D 0D 0D 0D 0D 0D 0D 0D
PATH ONLINE Y N N N N N N N
CHP PHYSICALLY ONLINE Y N N N N N N N
PATH OPERATIONAL Y N N N N N N N
MANAGED N N N N N N N N
CU NUMBER 1580 1580 1580 1580 1580 1580 1580 1580
INTERFACE ID 0000 .... .... .... .... .... .... ....
MAXIMUM MANAGED CHPID(S) ALLOWED: 0
DESTINATION CU LOGICAL ADDRESS = 02
SCP CU ND = 002107.985.IBM.75.0000000GZY11.0000
SCP TOKEN NED = 002107.900.IBM.75.0000000GZY11.0200
SCP DEVICE NED = 002107.900.IBM.75.0000000GZY11.0200
WWNN = 5005076308FFD02A
HYPERPAV ALIASES CONFIGURED = 192
FUNCTIONS ENABLED = MIDAW, ZHPF, XPAV

DEVSERV PATHS command

The MVS DEVSERV PATHS command shows the status of the specified base device.
Run this command using the following syntax:
DS P,device_unit_ID
The following figure shows a sample output of this command.
DS P,8300
IEE459I 15.43.32 DEVSERV PATHS 755
UNIT DTYPE
RTYPE
8300,33903 ,O,000,PA8300,63=< 40=+ 64=+ 65=+
2105
************************ SYMBOL DEFINITIONS ************************
O = ONLINE
< = PHYSICALLY UNAVAILABLE

DEVSERV QPAV commands

You can use the MVS DEVSERV QPAV commands to complete the following operations:
• Show the status of PAV base devices.
For more information about showing the status of PAV base devices, see Showing the PAV base
device status.
• Show the status of an HPAV base device and its alias devices.
For more information about showing the status of HPAV base devices and its alias devices, see
Showing the status of HPAV or Super PAV base devices and alias devices on page 53.
• Show the SSID status.
52 DEVSERV PATHS command
M CNT VOLSER CHPID=PATH STATUS
SSID CFW TC DFW
8300 Y YY. YY.
PIN DC-STATE CCA
N SIMPLEX 00
+ = PATH AVAILABLE
DDC ALT CU-TYP
00 2105