HPE XP7 User Manual page 27

7. On the Define Device / Processor screen, complete the following and then press Enter.
Specify or revise the following values.
Device number
Device type
Processor ID . . : SYSTEM#S
Unit address . . . . . . . . . . 01
number)
Time-Out . . . . . . . . . . . . No
STADET . . . . . . . . . . . . . Yes
Preferred CHPID
Explicit device candidate list . No
F1=Help
F12=Cancel -
8. On the Define Device to Operating System Configuration screen, select the operating system to
which you want to connect the devices and press Enter.
• For Unit address, if the address is different than the last two digits of the device number, type the
unit address.
• For Time-Out, select Yes or No.
Default: No
• For STADET, select Yes or No.
Default: Yes
• For Explicit device candidate list, select Yes or No.
Default: No
Define Device to Operating System Configuration
1
Command ===>
Select OSs to connect or disconnect devices, then press Enter.
Device number
Device type
/ Config. ID
Define Device / Processor
. : 8101
. . : 3390B
. . . . . . . .
F2=Split F3=Exit
. : 8101
. . : 3390B
Type Description
Number of devices . . . . : 1
Lab System - F9 - Skyline
+ (Only necessary when different from
the last 2 digits of device
(Yes or No)
(Yes or No)
+
(Yes or No)
F4=Prompt F5=Reset
Scroll ===> CSR
Number of devices
F9=Swap
Row 1 of
: 1
Defined
Defining devices 27