Verifying And Monitoring Devices; Verifying The Device Definitions - HPE XP7 User Manual

Verifying and monitoring devices

Verifying the device definitions

Use this task to verify that the host recognizes the devices as specified.
Procedure
1. Run the MVS DEVSERV QPAV command, using the following syntax:
DS QPAV,device_unit_ID,VOLUME
Information about the base device and corresponding alias addresses are shown.
The following is sample output of this command on a PAV device.
DS QPAV, D222,VOLUME
IEE459I 08:20:32 DEVSERV QPAVS 591
HOST
CONFIGURATION
-------------
UNIT
NUM UA
--- --
D222 22
D2FE FE
D2FF FF
***3 DEVICE(S) MET THE SELECTION CRITERIA
The following figure shows sample output of this command on an HPAV or Super PAV device.
DS QPAV,5000,VOLUME
IEE459I 22.28.19 DEVSERV QPAVS 726
HOST
CONFIGURATION
-------------
UNIT
NUM UA
--- --
05000 00
**** 1 DEVICE(S) MET THE SELECTION CRITERIA
NOTE: The relationship between base and alias devices does not appear as fixed to the operating
system when using HPAV. Therefore, only the information about base devices is shown.
2. Verify that the information shown matches the base and alias device definitions displayed by Remote
Web Console.
TYPE STATUS
---- ------
BASE
ALIAS-D222
ALIAS-D222
TYPE STATUS
---- ------
BASE-H
SUBSYSTEM
CONFIGURATION
-------------
UNIT UA
SSID ADDR TYPE
---- --- ----
0102 22 BASE
0102 FE ALIAS-22
0102 FF ALIAS-22
SUBSYSTEM
CONFIGURATION
-------------
UNIT
SSID ADDR
---- ---
5150 00
Verifying and monitoring devices
UA
TYPE
----
BASE
47