Moving The Sas Controller Retention Bracket - IBM x3650 - System M2 - 7947 User Manual

Moving the SAS controller retention bracket

Note: This procedure applies only to servers that have the following SAS riser
card.
USB hypervisor
connector
To move the SAS controller side retention bracket to a different position to
accommodate the dimensions of the current SAS ServeRAID controller, complete
the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Make sure that the server and all peripheral devices are turned off and that the
3. Remove the SAS riser-card assembly from the server (see "Removing the SAS
4. Remove the ServeRAID controller from the SAS riser card.
PCI Express SAS
controller connector
USB
tape
signal
on page 36.
power cords and all external cables are disconnected.
riser-card and controller assembly" on page 91).
SATA tape signal
Tape drive
power
SAS controller
error LED
SAS riser card
(tape-enabled model server)
Chapter 2. Installing optional devices
101