Lectrical Connection; Feedthrough For Wiring; Configuration Of Outputs And Inputs - iDM AERO ILM 2-7 Technical Documentation Installation Instructions

The electric switching cabinet is posi-
tioned below the fan. Both front panels
including the touch display have to be
removed. Then the lower cover of the re-
frigerant part has to be removed. Finally
it is possible to remove the cover of the
electrical cabinet itself.

7.2. Feedthrough for wiring

The feedthrough for the supply lines into the cabinet
is carried out by the free grommet on the left side.
The sensor cables which have to be installed on site,
have to be feed through the grommet on the right
side.
(C) IDM Energiesysteme GmbH
supply lines
7.3. Configuration of outputs and inputs
unit is derived from the electric circuit diagram relat-
ing to the system.
The sensor lines must be laid separately
Together with each heat pump a standard
sensor set is supplied. This is included
and stored in the control cabinet of the
heat pump.
Installation instruction AERO ILM
Electrical connection
sensor lines
59