Ap Front Panel View; Ap Rear View - junger V*AP Manual

V*AP front panel view
The front panel of the V*AP has a 3 line status display and a hidden touch button 2.5cm left from the display:
Display level 1
Display line 1
2
3
Display level 2
Display line 1
2
3
Display level 3
Display background colour
V*AP rear view
For fail safe operation, the V*AP provides two independent power supplies. These power supplies operate in
load balance. The status of both PSUs are combined with other status information and displayed as the front
panel display back light colour. On the X*AP RM
STATUS
INIT /
RESET
LAN
USB
ISO-PWR
GPI/O
Interface 1
SYNC IN
WCLK-OUT
AES / EBU IN
AES / EBU OUT
Interface 2
Power up display
Status [OK / ERROR]
Device name
IP address
Level display
Status [OK / ERROR]
Mic 1 / 2L
Mic 2 / 2R
IP address QR code
Green = hardware status OK
Red = hardware status ERROR
remote panel, are two independent status LEDs.
1
shows the status of the device controller
pressing the INIT button briefly will warm start the device controller.
Holding down the button until the STATUS LED flashes 3 times will initialize the
V*AP to factory default
RJ45 socket for Ethernet connection to a LAN
USB 2.0 type B socket to connect the built in USB >> serial converter with an
external PC
lights up if the isolated 5V power supply for GPI /O application is turned on
25pin Sub-D female connector to interface with the 8 optical isolated general
purpose inputs and 8 solid state relay closure outputs
slot to mount one of the optional interface boards (SDI, AES, analog)
75Ohm BNC connector to connect with external sync sources
75Ohm BNC connector to synchronize external devices to the V*AP internal
word clock
AES3 input
AES3 output
slot to mount the optional dual high end microphone pre amp module
or the optional dual AES42 module for digital microphones
4
V*AP