Table of Contents
Advertisement
EASY LOUDNESS
EASY LOUDNESS front panel view
The front panel of the EASY LOUDNESS has four LEDs to show the general summarized status as well as
power supply and audio bypass (maybe activated by an X*AP remote panel only).
EASY LOUDNE rear view
For fail safe operation, the EASY LOUDNESS provides two independent power supplies. These power
supplies operate in load balance.
STATUS
INIT /
RESET
LAN
USB
ISO-PWR
Interface 1
GPI/O
SYNC IN
WCLK-OUT
AES 1/2 IN / OUT
shows the status of the device controller.
pressing the INIT button briefly will warm start the device controller.
Holding down the button until the STATUS LED flashes 5 times will initialize the
EASY LOUDNESS to factory default.
RJ45 socket for Ethernet connection to a LAN.
USB 2.0 type B socket to connect the built in USB >> serial converter with an
external PC
lights green to indicate that the isolated 5V power supply for GPI /O application
is available.
slot to mount one of the optional interface boards (SDI, MADI, DANTE, AES,
analog).
25pin Sub-D female connector to interface with the 8 optical isolated
general purpose inputs and 8 solid state relay closure outputs.
75Ohm BNC connector to connect with external sync sources.
75Ohm BNC connector to synchronize external devices to the
EASY LOUDNESS internal word clock.
AES3 (XLR) and AES3id (BNC) input (selectable via GUI) / output (parallel)
3
Advertisement
Table of Contents
