Rear Panel - junger Accent1 Operation Manual

4. LOCATION OF PARTS AND CONTROLS
4.2
DIGITAL OUTPUTS
SERIAL
DIGITAL INPUTS
REMOTE
accent2 REMOTE
230 V
50 Hz
GPI
200 mA
GPI
REMOTE/
TALLY
fig. 2: rear panel ACCENT2
POWER INPUT
IEC mains input connector 100-240V, 50/60 Hz with integrated fuse
REMOTE
serial remote interface RS-232
connector:
GPI
parallel remote interface GPI in/TALLY out
connector:
SYNC
EXT SYNC
input for external sync signal
wordclock, TTL level, 1 kOhm, unbal.
connector:
W-CLOCK
output for sync signal
wordclock, TTL level, unbal.
connector:
FADER
input for remote fader
connector:
DIGITAL IN
input for AES/EBU standard format
connector: XLR female panel jack, 1- ground, 2-3 signal, balanced
connector: BNC socket 75 Ohm, unbalanced
DIGITAL OUT
output for AES/EBU standard format
connector: XLR male panel jack, 1- ground, 2-3 signal, balanced , 4 Vpp
connector: BNC socket 75 Ohm, unbalanced, 0.5V pp
ANALOG IN
input for analog audio signals
connector: XLR female panel jack, 1- ground, 2- hot, 3- cold, 10kOhm, floating balanced
ANALOG OUT
output for analog audio signals
connector: XLR male panel jack, 1- ground, 2- hot, 3- cold, 50Ohm, floating balanced
page 4-2 Operation manual ACCENT2, chapter 4 -location of parts and controls -
DIGITAL INPUT
BNC1
BNC2
XLR1 XLR2
9pin SUB-D, female
9pin SUB-D, female, TTL-level
BNC socket,
BNC socket
6.3 mm phone plug
SYNC
IN/OUT ANALOG
INPUTS
DIGITAL OUTPUT SYNC IN
BNC1
FADER
BNC2
XLR1 XLR2
WCLK OUT
FADER

REAR PANEL

ANALOG
OUTPUTS
ANALOG OUTPUT
ANALOG INPUT
LEFT LEVEL RIGHT LEFT LEVEL RIGHT