Setup Gui - Events - Events - I/O Events - junger V*AP Manual

You are able to create a new preset event by pressing <create event> :
Empty
Include these Blocks
Setup GUI – EVENTS – Events – I/O Events
I/O events at the moment are restricted to control the GPOs of the V*AP :
Each GPO (when incorporated into that I/O event) can be set to the behavior as follows :
Clear
Set
Follow
Toggle
Event name
.
Use Settings from [On Air / Existing Event / Empty]
On Air
.
Important note ! This is the way to create your own
snap shot. The new preset will be given the name of this
event automatically! So be careful in selecting
meaningful names. You will find them later on in your
function blocks!
Existing Event
Creates a set of empty fields where you may select the preset of
your choice for the respective function block or leave it empty if no
changes are needed ...
[System / Interface / Routing / Audio Porcessor / Voice 1 / Voice 2 /
Program 7 Monitor]
You can tell the event manager which function blocks must be
included in this event.
Turns a GPO off that was previously turned on.
Turns a GPO on.
The GPO follows the state of the trigger.
The trigger will toggle that GPO.
48
[John Wayne]
A unique name to address this preset
event later in the action manager.
The events manager will
all On Air parameters to
in all function blocks (depending on
the "Include" check boxes).
you will be asked. The presets of the
selected event will copied to the new
event and may be marginally tuned
afterwards to form a slightly different
event.
V*AP
copy
new presets