Getting Started - Ip Setup Of The V*Ap - Via Web Browser - junger V*AP Manual

V*AP
Getting Started – IP setup of the V*AP
* Read the default IP address printed on a label at rear of the device.
* Set up network parameters of your PC to fit the default IP address of the V*AP (net mask = 255.255.0.0).
* Connect the V*AP with the PC either by an Ethernet cross over cable or by a switch.
* Open a browser and type IP address of the V*AP into the URL field and press <ENTER>.
This will open the AUDIO PROCESSOR tab sheet of the GUI.
* Click on <SYSTEM> and the "Admin" tab will open automatically :
Enter the desired network configuration and press <apply>
Afterwards you must reboot the V*AP in order to activate the new IP configuration.
Regarding Gateway address see above.
Important Note! After reboot neither the web browser nor the X*AP RM
communicate with the V*AP. You must fill in the new IP address in the URL field and change
the X*AP RM remote panel settings to attach this device again.
1
via web browser
–
9
remote panel may be able to
1