Table of Contents
Advertisement
Select item "8: Reboot" <ENTER>
Do you want to reboot the device ?
Press small "y" <ENTER>
Rebooting the device ........
After reboot has finished, the new IP configuration is active and will be displayed at the top of the
configuration menu.
Getting Started – IP setup of the EASY LOUDNESS
* Read the default IP address printed on the label at the rear of the device.
* Set up network parameters of your PC to fit the default IP address of the EASY LOUDNESS
(e.g. default IP +1 and net mask = 255.255.0.0).
* Connect the EASY LOUDNESS with the PC either by an Ethernet patch or a cross over cable
(if the PC does not support Auto MDI-X) or via a switch.
* Open a browser and type the default IP address of the EASY LOUDNESS into the URL field
and press <ENTER>. This will open the HOME tab sheet of the GUI.
* Click on <SYSTEM> and afterwards the "Admin" tab:
Enter the desired network configuration and press <apply>
Afterwards you must reboot the EASY LOUDNESS in order to activate the new IP configuration.
Important Note! After reboot neither the web browser nor the X*AP RM
communicate with the EASY LOUDNESS. You must change back the IP configuration of the PC to your
actual network and fill in the new IP address in the URL field. You must set-up the X*AP RM
as well to attach this device (see X*AP manual for details).
EASY LOUDNESS
via a web browser
–
1
8
remote panel may be able to
remote panel
1
Advertisement
Table of Contents
