INSTALLATION
UNPACK THE UNIT
The digital dynamics processor ACCENT2 was
carefully packed in the factory and the
packaging
was
designed
equipment from rough handling.
POWER SUPPLY
The digital dynamics processor ACCENT2 is a
device
under
the
Schutzklasse1 in keeping with the VDE 0804
standards and may only used with power
supply
installations
regulations.
CONNECTIONS
The digital dynamics processor ACCENT2 is
equipped with standard connectors (see also
chapter 4).
RACK MOUNTING
The digital dynamics processor ACCENT2 is
made as standard 19" unit (EIA format). It
occupies 1 RU (44 mm height) space in a rack.
Please allow at least addititonal 3" depth for
the connectors on the rear panel.
OPERATION SAFETY
The digital dynamics processor ACCENT2
should not be installed near units which
produce strong magnetic fields or extreme
heat. Do not install the filter processor directly
above or below power amplifiers.
to
protect
the
safety
category
built
according
to
operation manual accent2 chapter 3 -Installation- page 3-1
Please examine carefully the packaging and its
contents for any signs of physical damage,
which may have occured in transit.
Check the voltage details printed at the rear
panel are the same as your local mains
electricity supply.
Before
connecting
processor ACCENT2 switch the power off at all
connected units.
When installing the unit in a 19" rack the rear
side of the unit needs some support, especially
for mounting in flight cases.
If, during operation, the sound is interrupted or
displays no longer illuminate, or if abnormal odor
or smoke is detected immediately disconnect
the power cord plug and contact your dealer or
Jünger Audio.
3. INSTALLATION
3
3.1
3.2
3.3
the
digital
dynamics
3.4
3.5