Table of Contents
Advertisement
Display Layout
The following figure shows the display when two windows are configured
in the dual numeric mode.
Other display formats are available by pressing
Figure 1-1 Dual numeric display
1 The status reporting line displays messages and the control status of
2 The measured channel is shown with a thermistor sensor connected.
3 This field displays the current bridge resistance value as an indicator
4 The information in this field is displayed in two lines and depends on
5 This field displays the menu title.
N432A User's Guide
1
2
3
the N432A.
For example, the status can be either RMT (remote, GPIB, USB, or LAN
operation) or LCL (local, front panel operation). The message field will
indicate ERR for any error conditions that occur.
with or without the thermistor sensor connected.
the sensor calibration factor, sensor calibration and
frequency- dependent offset tables currently selected, and the
measurement frequency.
For example, Channel Setup, or press
displayed.
4
and the Zero/Cal menu is
Introduction
1
>
.
Disp Type
5
6
7
8
9
11
Advertisement
Table of Contents
