Table of Contents
Advertisement
2
Operating Information
Displaying Voltage Measurements
The N432A allows you to view the voltage measurement values for the
selected measurement window. Values of V
V
measurement value, PV
PV
N O T E
details on offset configuration, refer to
V
with the RF source disconnected. After zeroing, V
measured with the RF source turned on.
The voltage measurement range for V
V
The values for V
6.5- digit resolution. The V
voltage value is more than 1 VDC and in mVDC if the voltage value is less
than 1 VDC; with a 6.5- digit resolution.
Procedure
Use the following steps to display the voltage measurement values:
1 Press
2 Press
Figure 2-6 Voltage measurement display
38
are displayed together with the associated average power
RF1
is obtained after any channel offset has been applied but prior to any display offset. For
1
, V
, and V
0
COMP0
RF0
and V
have a default measurement range of –0.625 V to 1.875 V.
0
1
and V
RF
to access the display format menu.
and select
1 of 2
measurement values will be displayed as shown in the example below:
.
1
"Setting Offsets" on page
values are determined when zeroing is performed
and V
RF
are displayed in the VDC unit with a
COMP
and V
values are displayed in VDC if the
0
1
. The voltage and average power
Voltages Display
, V
, V
, V
, V
0
COMP0
RF0
1
41.
, V
, and V
1
COMP1
is –200 mV to 10 V.
COMP
N432A User's Guide
, and
COMP1
are
RF1
Advertisement
Table of Contents
