Instrument Self-Test; Figure 3-1 Self-Test Completed - Keysight Technologies N432A User Manual

Instrument self-test

When
are the same tests run using the *TST? command.)
• Test Point Voltages
• Calibrator
• Fan
• RTC Battery
• V
• V
• V
When
sensor is connected. If connected, you will be prompted to disconnect the
sensor.
Once
disconnected. If disconnected, self- test will initiate and display the test
results accordingly.
As each test takes place, the name of the test is listed on the screen.
While a test is running, the message Testing... appears beside the name of
the test. As each stage of the test completes, the Testing... message is
replaced by either Passed or Failed.

Figure 3-1 Self-test completed

N432A User's Guide
Instrument Self Test
Path
RF
Path
COMP
Path
0
Run Self Test
is pressed, the N432A will check if the thermistor
Confirm
is pressed, the N432A will check if the sensor is
is selected, the following tests will be run: (These
Maintenance 3
99