Figure 2-17 Offset Display In The Engineering Unit (When The Selected Unit Is %) - Keysight Technologies N432A User Manual

If the selected offset unit is %, the display of the offset will be in the
engineering unit only if the percentage value is <0.01% or ≥10000%. The
format of the display in the engineering unit for an offset ≥10000% will be
shown as follows:
For example,
The format of the display in the engineering unit for an offset <0.01% will
be shown as follows:
For example,

Figure 2-17 Offset display in the engineering unit (when the selected unit is %)

N432A User's Guide
xxxx.yyyyyyyy e+z
• There is a maximum of four numbers before the decimal point,
indicated by x.
• y is optional if there are zero numbers after the decimal point.
• 123478202 will be displayed as 1234.78202000 e+5
• 10000 will be displayed as 1000.00000000 e+1.
x.yyyyyyy e–z
• The first leading non- zero number, x, is placed before the decimal
point.
• y is optional if there are zero numbers after the decimal point.
• 0.009876 will be displayed as 9.8760000 e–3
• 0.0001 will be displayed as 1.0000000 e–4.
Operating Information 2
51