Maytag MXS20 Programming Manual page 63

FAILURE 38: NO RECYCLE WATER
Failure 38 occurs when the electronic timer detects that the Water Recycle tank is empty.
DIAGNOSE:
1. Check the water level from the water recycle tank.
FAILURE 39: EMPTY SOAP SUPPLY BOX
Failure 39 occurs when the electronic timer detects that the Soap Reservoir is empty. To ensure Liquid Soap is added during the wash
process, the operator gets a signal when a Liquid Soap Supply Reservoir is almost empty.
DIAGNOSE:
1. Check if the Liquid Soap Supply is empty.
FAILURE 41: SERVICE DUE SIGNAL
Failure 41 occurs when the cycle counter of the Electronic timer has reached the Programmed Value for Service due. The Fault Message
will be erased by opening the door. If the cycle counter has not been reset, the message will appear again at the end of the next wash cycle.
DIAGNOSE:
1. Check the cycle counter. The value can be found in the
Service Info Menu. The third menu item shows the cycle
counter.
FAILURE 42: NO NETWORK CONNECTION
Failure 42 occurs when there is No Network Connection available. For more information about Networking see the manual "Trace-Tech."
DIAGNOSE:
1. Check the network cable.
2. Check the USB RS485 converter.
FAILURE 43: INCORRECT VOLTAGE RANGE SELECTION
Failure 43 occurs when the incorrect Voltage Range has been selected in the Configuration Menu. Depending on the Machine Type
and the Inverter Type, certain Voltage ranges are not allowed.
DIAGNOSE:
1. Check the Washer Data plate at the back of the washer.
FAILURE 44: INCORRECT MACHINE TYPE SELECTION
Failure 44 is displayed when the operator selects the freestanding washer option (i.e. washer with a safety switch) on a rigid-mount washer
(i.e. washer without a safety switch).
DIAGNOSE:
1. Check the Washer Data plate at the back of the
washer.
Add water to the water recycle tank.
Add Soap to the Liquid Soap Supply System.
You can reset the cycle counter in the Service Info Menu.
If the network cable is broken, replace the network cable.
If the converter is out of order, replace it.
Select the same Voltage range in the Configuration Menu as on
the Identification plate of your washer.
Menu Item C: Supply Voltage
Select the correct Machine Type in the Configuration Menu.
63