Initialization Menu - Maytag MXS20 Programming Manual

Initialization Menu

Initialization Menu allows you to choose standard default program
settings for your application.
1. Make sure power is ON and no program is running.
2. "Select Cycle" is displayed.
3. Enter SETUP MODE. The Main Menu will be displayed.
4. The Initialization Menu is the first menu.
Main Menu
Initialization ...
Program ...
Service ...
Menu Item
Language
Service Interval
Buzzer Time
Allow Advance
Automatic Cool Down
Wait for Temperature
Manual Override
Temperature Balance
Motor On Time
*Automatic Cool Down
To avoid mechanical temperature shock and to extend the lifetime of your washer, after a hot wash, cold water is injected bit by bit.
n
As a result at the end of the hot wash, the temperature will be lowered to about 65°C (150°F).
The automatic cool down function will only be functional if a hot wash with a temperature above 65°C (150°F) has been
n
programmed and if a cold water inlet valve is programmed in the next step. When a Cool down sequence has been programmed,
the automatic cool down will not function.
The automatic cool down differs from a normal cool down sequence. The purpose of a normal cool down sequence is to avoid
n
the shrinking of the garments. (Takes more time).
18
Configuration ...
Advanced ...
Initialization Menu Selections and Defaults
Description
Language selection for Program Mode: English,
Spanish, French, etc.
Number of cycles at which maintenance is required.
3000: Top Soap Dispenser washers
9999: Servicing interval is ignored
The time the Buzzer beeps at end of wash cycle while
"Unload" is displayed.
The Advance function allows the user to skip a
sequence or change sequence duration.
Automatic cool down selection*.
Wash Process time is put on hold until the programmed
temperature is reached. Once the temperature has been
reached, the wash cycle time will decrease.
NOTE: For models without internal heating, the setting
must be changed to "No" for proper washer functioning.
Activates the Special Function keys on the touch pad.
The operator can directly operate the water inlet, drain,
heating, and spin speed functions.
NOTE: It is not possible to manually direct the washer
to perform an unsafe sequence of functions.
The correct water temperature for the water fill process is
obtained by switching the cold and hot water inlet valves.
NOTE: For proper wash cycle temperatures, the setting
must be changed to "Yes."
Normal wash action, drum turns for 12 seconds.
Recommended 3 sec for Gentle wash action.
(= suggested values for the Program Menu)
5. Press ENTER
.
6. Press 5 or 6 to select the desired menu item.
Default Range
English List
3000 1–9999
5 sec 0–99
Yes No/Yes
Yes No/Yes
Yes No/Yes
Yes No/Yes
No No/Yes
12 sec 1–99 sec