Maytag MXS20 Programming Manual page 31

The Spray Sequence
Prewash Wash
n Water or Liquid is injected at Distribution or Low Spin Speed
n No standard water inlets can be programmed in this function.
n The liquid will be injected based on soap supply programming.
Menu Item
RPM
Drain Valve
Detergents Menu...
Supply 1, ..., 8
Signal
No Wash Sequence
Prewash Wash
In case of a No Wash Sequence, the wash function of the programmed step is skipped.
Cool Down Rinse
Description
The suggested RPM depends on the Machine Type.
Only available on washers with both:
a normal Open and normal Closed Drain valve.
Time selection for external liquid soap supplies.
You can program up to 4 supplies at the same time.
If you have programmed more than 4 supplies an error
message will be generated.
Reset the time of the supplies back to 0. Only 4 non-zero times
values can be programmed.
– Liquid soap supplies must be switched on in the
Configuration Menu.
When a signal is programmed, a pause will be introduced at the
end of the Wash Step. This allows the operator to add soap for
the next step. A buzzer signal warns the operator that the cycle
has been interrupted.
Cool Down Rinse
Spray
Final Rinse Soak
Final Rinse Soak Spray
No Wash
Default Limits
– See Table A-5
1 1–2
0 sec 0–99 sec
No No/Yes
No Wash
31