Maytag MXS20 Programming Manual page 30

The Soak Sequence
Prewash Wash
Menu Item
Temperature
Inlet
Level
RPM
Detergents Menu...
Supply 1, ..., 8
On Time
Off Time
Time
Signal
30
Cool Down Rinse
Description
The water temperature
The suggested Inlet Valves are related to the
temperature and the Soap Box to be used.
IMPORTANT: If you insert Inlet Valves other than those
suggested, problems can occur at the water fill process.
The suggested water level depends on the Machine Type.
The suggested RPM depends on the Machine Type.
Time selection for external liquid soap supplies.
You can program up to 4 supplies at the same time.
If you have programmed more than 4 supplies an error
message will be generated.
Reset the time of the supplies back to 0. Only 4 non-zero times
values can be programmed.
– Liquid soap supplies must be switched on in the
Configuration Menu.
The wash action, motor On Time.
(The suggested default values can be adjusted at the
Initialization Menu)
The wash action, motor Off Time.
(The suggested default values can be adjusted at the
Initialization Menu)
The Soak Sequence Time.
(for 0 minutes the Soak Sequence will be skipped)
(programmable in steps of 0.1 minutes)
When a signal is programmed, a pause will be introduced at the
end of the Wash Step. This allows the operator to add soap for
the next step. A buzzer signal warns the operator that the cycle
has been interrupted.
Soak
Final Rinse Spray No Wash
Default Limits
104°F 33.8–113°F
(40°C) (1–45°C)
11–17 11–18
Normal See Table A-3
Low
– See Table A-5
0 sec 0–99 sec
12 sec 1–99 sec
10 min 1–99 min
1 hour 0–25.5 hour
No No/Yes