Service Menu - Maytag MXS20 Programming Manual

Service Menu

In the Service Menu you have some extra utilities:
 The Software Version Number.
 An overview of the 20 last Failure Messages.
 Statistics for 10 general error messages.
 Pulley Ratio.
 An overview of the input states.
 Switching On the Inverter for a technical intervention.
 Reset Cycle Counter and Statistics Error Messages.
HOW TO GET INTO THE SERVICE MENU
The Service Menu can only be accessed when the washer
is in standby (the power is switched on, but no program
is started).
Main Menu
Initialization ...
Program ...
Service ...
Fault Menu
Menu Item
View Fault Messages ...
1 Fault 1: E XXX: YYYYYYYYYYYY
20 Fault: E XXX: YYYYYYYYYYYY
Erase Fault Messages
View Fault Statistics ...
1 No Drain
Configuration ...
Advanced ...
Description
Check the last 20 Fault Messages from the Err log Fault N° 1: the last
occurred error message
Fault N° 20: the last – 20 occurred error message
E XXX: The Error message number
YYYYYYYYYYYY: The Error message name
(If no messages are displayed, this means that no Errors have occurred.)
No The Error log is reset by erasing the Fault Messages.
The Fault Statistics are an accumulation of Error messages that have
appeared over a long period. With this information the technician has an
0x
indication on which parts an intervention should be needed. (The statistics
are reset by the "Reset Service Counts" menu item in the Toolbox Menu.)
The List with Statistics:
No Drain: E2 + E37
Door Switch: E6 + E7 + E8 + E9
No Fill: E11 + E40
No Heating: E13 + E14
Temp Sensor: E25
Level Sensor: E24
Safety Switch: E3
Invert Com: E27
Invert Alarm: E26 + E28 + E29 + E72 + E73 + E74 + E75
Lock Active: E78 + E79
Invert OV Alarm: E303 + E304 + E305
SELECT CYCLE is displayed.
 Enter the Setup Mode. (See page 5.)
 The Main Menu is now available.
 Press ARROW DOWN to select the Service Menu.
 Press ENTER to make your selection.
 Now you will see the Service Menu Screen.
 The software version is prominently displayed on the
Service Menu. Write this information down on the back
cover of this manual.
Service Menu
Software Version: 771.100.0
Diagnostic Prog ...
Faults ...
Toolbox ...
Exit
51