Maytag MXS20 Programming Manual page 19

Menu Item
Motor Off Time
Smart Motion
Hot Water Heater Temp.
Temp. Overshoot Prot.
Max. Heating Time
Max. Water Fill Time
Overfill Detection
External Wait Control
Prewash Soap Info
Wash Liquid Soap Info
Main Water Pressure
Step Info
Show Step Temp.
Exit
Initialization Menu Selections and Defaults (continued)
Description
Drum is stopped for 3 seconds for normal action.
12 sec recommended for Gentle wash action.
(= suggested values for the program menu)
This option decreases the drum RPM during water filling;
therefore, the laundry absorbs water more quickly and washing
efficiency increases.
The water heater temperature should be the same
as the temperature of the hot water supply.
This is the % below the target temperature heat is switched off
to avoid overshoot. Heating will begin after 30 seconds if the
target temperature is not reached.
Generates an error message if the target water temperature is
not reached within the Maximum Heating time (Err 14).
If 99 is entered, no error message will display. The washer will
continue heating until the target water temperature is reached.
Generates an error message if the target water level is not
reached within the Max. Water Fill Time (Err 11). If 99 is entered,
no error message will display. The washer will continue filling
until the target water level is reached.
An error message is generated if the water level exceeds the
programmed water level by more than the programmed number
of units (Err 12). If the washer uses steam heating, the steam
installation should have adequate power to quickly heat the
water. Slow heating will raise the water level and also cause
increased energy and laundry product consumption. Reduce the
programmed water temperature to the minimum level necessary
to achieve satisfactory results.
Liquid soap supply system:
Selection for a washer connected to a central liquid soap supply
system.
The central pump system is able to pause the washer, before
continuing the wash process, until the central pump system is
free to pump the liquid soap supply into the washer.
Heating, (for installations with limited power supply): You can
disable the heating system of the washer with an external signal.
The heating will switch on again, and the wash process will
continue, as soon as the external signal is switched off.
Wait:
External signal suspends the whole wash process until the
external signal gets switched off.
Time:
External signal stops the countdown of the washing process.
All functions of wash cycle continue. When the external signal
stops, the countdown will continue.
Use to display prewash soap dosage.
Use to display main wash soap dosage.
Set to "Low" if the water pressure is weak or if the water supply
pressure decreases notably during delivery.
Use to display current operating step.
Use to display temperature of water (°C) during the wash cycles.
Return to Main Menu
Default Range
3 sec 1–99 sec
No No/Yes
140°F 122–176°F
(60°C) (50–80°C)
00 % 0–30 %
60 min 10–90 min
99
10 min 5–99 min
5 units 3–25 units
Off Off/Soap/
Heating/Wait
Time
Yes No/Yes
Yes No/Yes
High Low/Medium/
High
No No/Yes
Yes No/Yes
19