A 2.4.10 Setting The Measured Value Server; A 2.4.11 Baudrate; A 2.4.12 Save Parameter; A 2.4.13 Load Parameter - MICRO-EPSILON C-Box/2A Operating Instructions Manual

Appendix | ASCII Communication with Sensor

A 2.4.10 Setting the Measured Value Server

In case of measured value output via Ethernet: currently only TCP server is provided.
- The port is freely selectable between 1024 and 65535.
Default = SERVER/TCP 1024

A 2.4.11 Baudrate

Setting the interface baudrate to the PC. Possible variants: 115.200 (Default), 8.000.000, 4.000.000,
3.500.000, 3.000.000, 2.500.000, 2.000.000, 1.500.000, 921.600, 691.200, 460.800, 230.400, 9.600 Baud
Default = 115200

A 2.4.12 Save Parameter

Save the current parameter under the specified number in the flash. With the restart of the C-Box/2A the last
saved data record is always loaded.

A 2.4.13 Load Parameter

Read the current parameter under the specified number in the flash. In addition, the size of the loaded data
needs to be specified:
- ALL: All parameters are loaded.
- DEVICE: Only the standard device settings are loaded (interface parameter).
- MEAS: Only the measurement settings are loaded (all features for the measurement).

A 2.4.14 Default Settings

- Sets the default values (Reset to default setting).
- ALL: All setups are deleted and default parameters are loaded, otherwise, only the current setup will be
- NODEVICE: Settings of IP address are kept temporarily.
C-Box/2A
MEASTRANSFER SERVER/TCP [<PORT>]
BAUDRATE <Baudrate>
STORE 1|2|3|4|5|6|7|8
READ ALL|DEVICE|MEAS 1|2|3|4|5|6|7|8
SETDEFAULT [ALL] [NODEVICE]
deleted.
Page 89