MICRO-EPSILON C-Box/2A Operating Instructions Manual page 26

Operation
i
compatible file inclusive timing information.
The menu item
are stored with a dot as decimal mark if the language is set to English, otherwise a comma is used.
Only a limited number of measured values can be stored (about 50,000).
i
Each curve can be deactivated and activated using the associated checkbox (checkmark). In addition, the
horizontal scrolling (slider) is possible in the diagram.
The
The
on the C-Box/2A or the sensors connected.
Use the
value, for example, for performing differential measurements.
You can do this also in the menu
The y-axis can be scaled manually or by using the
C-Box/2A
By letting the diagram display run in a separate tab or browser window, you avoid having to restart the
display every time.
Start
Click the button to begin displaying measurement results.
Stop
Click the button to stop displaying measurement results.
Save
Click button to save the previously accumulated measurement and calculation results in a CSV
Save
stores the measured values after the measurement was stopped. The measured values
The oldest values will be overwritten when more values are captured.
Show
checkbox specifies which channels are displayed in the diagram.
Autozero
checkbox sets the selected channel to zero only in the diagram. This setting has to influence
Mastering
button to set the measurement value from the C-Box/2A to the selected measurement
Go to the menu bar at the side indicated below
Enter a master value (e.g. 0 for a differential measurement).
Set master value
Click the
Reset master value
Click the
Go to the menu bar at the side indicated below
0
Set the master value to .
Zeroing
button.
button to end mastering.
Zero setting / Mastering.
Preferences - Zeroing / Mastering, see Chap.
Autoscale
Mastering
/ .
function.
5.5.7
.
Page 26