Calibration - Jadever JWL-1.5K Manual

stable：Stable print（weight is equal or more than 20d）
key：Manual print by pressing key
13. P12: Print format
See the appendix (more than 100 formats. The appendix just shows two formats.)
14. P13: Filtering setting
Set the filtering level in which the stable indication turns on. The higher the setting, the
slower stabilization time
Options: 1，2，3，4
15. P14： Tare/Zero condition
stable ： Only after the stable indication appears, Tare/Zero function acts after pressing
TARE
down key
always： Tare/Zero function acts by pressing down key
stable
auto: Press down key
acts after stable
16. P15： RTC set
on: Enable RTC function
off: Disable RTC function
RTC setting:
When the window shows "on", press
the year. Press
setting. Press
HOLD/LO/-
or
17. P 16:
ON display the previous weight when powering on again
OFF not display the previous weight when powering on again
18. P17：
M-/SET
Press then press

6.Calibration

Note: Before calibration, please set the unit first. The unit used in calibration is the one that
ZERO
or
TARE ZERO
or
/MR TARE/
or
/MR TARE/
or to shift key leftward or rightward; Press
to change the value. Press
Zero-Offset function.
Initialization
M+/SAVE
(II)
PRINT
even if it is not stable, but Tare/Zero function
M-/SET
to enter RTC setting and the window shows
to choose date and time. Press
M+/SAVE
to initialization and the window display RESET.
JWL
TARE ZERO
or even if it is not
M-/SET
+/PRINT/HI
to return.
to enter
8