Calibration - Jadever 1.5K User Manual

M+
Press key or key
---p00-p11, indicated by Auxiliary display at the Lower Left corner.) then press key
to start the unit setting menu.
2) How to set the init weight unit?
UNIT/LO
Press key
setting menu---set the active weight unit.
4) How to set the active weight units?
UNIT/LO
Press key
ON/OFF the displayed weight unit, and press key
menu--- whether to retain the last used weight unit when the unit is turned on.
-- enable
-- disable
5) Whether to retain the last used weight unit when the unit is turned on?
M+
Press key to set whether to retain the last set weight unit when the unit is turned on, then
G/N
press key to save and return to normal weighing mode.
-- Last used weight unit is retained when the unit is turned on.
-- Last used weight unit is not retained when the unit is turned on.
Note: if enter the Unit setting menu by method 2, press key
ZERO/ESC
to return to normal weighing mode.

6. Calibration

1. For best results calibrate the scale at regular intervals. This is especially important if the
scale is in use for prolonged periods.
2. Calibration weights are not provided with the scale.
3. Here we take JWL-15K as an example.
Linear Calibration
1) Press and hold key
release the
TARE
2) Again press key
scale.
3) Wait till appears, put weights of 1/3 of full load on the weighing pan (E.g. for
M-
to choose setting item p11,(There are 12 available setting items
to set init weight unit and press key
to step through all the available weight units, press key
TARE
while powering on the scale. The screen displays
to enter the zero point calibration modes, with no load on the
G/N
to save and move to the next
G/N
to save and move to the next setting
G/N
to save and then press key
Vetek Weighing AB
UNIT/LO
M+
switch
", then