3-10 Brightness; Calibration; Normal Note; For Sealed Lead Acid Battery - Jadever JWI-501 Series Instruction Manual

3-9-5
Zero: set auto zero. Default = 1e
When it displays ZEro, press <
range：0.5d, 1d, 1.5d, 2d, 2.5d, 3d, 3.5d, 4d, 4.5d and 5d, d is division value when
SET/0~9
n=3000). Press <
3-9-6
bUZZEr: set buzzle. Default = off
When it displays bUZZEr, press <
off. on is using sound in upper and lower limit situation; off is without sound.
3-9-7
d: choose division. Default = 3000 division value
When it displays d，press <
TARE
Press < > to confirm, and there have three divisions of each capacity. When you
choose the little one, the speed of display will be slower.
3-9-8
on-rA: powering on range. Default=100
When it displays on-rA, press <
that no limit is imposed on the powering on range. In case the zero point upon
powering on is greater than 20% of the maximal weighing capacity, Err-0 and
Err-04 will be displayed upon powering on, and the tare should be reduced to less
than 20% of the maximal weighing capacity.

3-10 Brightness

ON/ZERO
Press and hold <
lu-1 is save power mode (Recommend). Press <
Default = lu-1

4 Calibration

ON/ZERO
1． Press <
mode (no wind and quaking) and under zero;
SET/0~9
2． Press <
capacity. Press <
c-3000，c-6000（c is capacity，unit is kg）;
TARE
3． Press <
4． Now it will show the offset value "0". If it is not 0, press <
5. Place some standard weights on plate. After offset value is stable, press <
TARE
> to choose. Press <
TARE
TARE
> to enter. Press <
TARE
>. it displays lc-. Press <
> to turn on. After self-inspection, it comes into normal weighing
> together with <
SET/0~9
> to choose c-30，c-60，c-150，c-300，c-600，c-1500，
> to confirm;
>to enter. It displays ZEro x.x(x.x is auto zero
TARE
> to confirm and return weighing.
> to enter. Press <
SET/0~9
> to enter. It will show 100 which indicates
SET/0~9
TARE
> to confirm.
ON/ZERO
> for 3 seconds，it shows the last
JWI-501
SET/0~9
> to choose on or
> to choose division.
> to choose lu-1, lu-2.
ON/ZERO
> to zero;
TARE
> to
5