Single And Multi-Point Calibration - Jadever JCL-3K Manual

SET11
12)
SET12
13)
1：Suitable in very stable environment with the quickest weighing
2：Suitable in the common environment
3：Suitable in a bit shaking environment
4：Suitable in the very shaking environment with the slowest weighing
SET13
14)
stable ：Taring or zeroing works when stable only
always：Taring or zeroing works no matter it is stable or not
auto： Press key TARE or ZERO when unstable, but it works when stable.
SET14
15)
RTC setting: press key
G N/SET
again to enter the RTC window. Press key
changing and key
PRINT/LO
to modify the value (or via numeric keys). Press key
shift the windows.
SET15
16)
On: display the last weight when powering on again
Off: do not display the last weight when powering on again
SET16
17)
Qty.ck: start amount checking
Wt.ck: start weighing checking
SET17
18)
G N/SET
press key
displaying OK.

6. Single and Multi-point Calibration

Note: Before calibration, please set the capacity first. The unit used in calibration is the one
that has been set before. During the calibration procedure, LONG press
return to normal weighing mode without saving.
Here we take 3kg/10g as an example
1. Press and hold
Do not release it till the window displays
2. With no load on the weighing pan,
printing format setting: prt01~prt03
filtering setting: 1, 2, 3, 4
zeroing or taring setting: stable, auto, always
time setting (optional): on, off
G N/SET
to enter RTC setting and set to on. Press key
TARE/
/MR
or
weight memory parameter: on, off
the kinds of checking: Qty.ck, Wt.ck
parameter initialization
M+/SAVE
then key
TARE/
while powering on.
(II)
G N/SET
to shift the figures. Press key
to start initialization. It is finished when
CAL"
"
to enter the figure
M-/HI
M+/SAVE
to save and
ZERO/ESC
or
to
8