Troubleshooting And Error Message - Jadever JWL-1.5K Manual

9. Troubleshooting and Error Message

Error Message Problem
Exceed the zero range
ERR0
ERR2 Exceed the initial zero point
Exceed
ERR3
range
ERR4 EEPROM failure
ERR5 Overload condition
Exceeds the display range
ERR6
Accumulated
ERR7 weighments
display range
Lower limit is higher than upper
ERR8
limit
ERR9 Exceed tare or pre-tare range
ERR10 Wrong calibration weights
(II)
the A/D resolution
number
exceeds the
JWL
shootings
The item should be within 2% of full load
1. Check whether there are other alien
articles on the scale pan, remove those
articles.
2. LOAD CELL failure, which requires to be
changed or to contact our Service.
1. Check whether it is A/D failure, if yes,
please replace AD.
2. LOAD CELL failure, replacement
required or contact our Service.
Re-sold EEPROM or contact our Service.
Remove weight that is greater than the scale
capacity from the pan.
--------------------------------------------
of Delete the exceeding weighments
re-act the upper limit setting and lower limit
setting
The tare value should be over zero and less
than or equal to full load.
Place the right weights( the calibration value
≤ full load)
is
14