Operation; Weighing - Jadever JWL-1.5K Manual

has been set before. During the calibration procedure, press
weighing mode without saving.
Here we take 3kg/1g as an example
1. Press and hold
"CAL".
2. With no load on the weighing pan, press
blanking at the left bottom.
3. Wait till the window displays the first calibration value. "
Note: The first calibration value is default. With the same capacity, the last first calibration
point value can be recorded. If the capacity has been changed, the default value is 1/3 of
full load. If you need to change the value, do as the following: Press
value setting. Press
+/PRINT/HI or HOLD/LO/-
Press
4. Put the corresponding weight on the weighing pan, and then press
the first point calibration. "
Note: After the first point calibration, the window can display the weight value. If no need
for the other point calibration, move to step 6 to finish the calibration procedure.
5. Add another mass to the current weight. The window will show the total weight. Press
to complete. "
TARE
M+/SAVE
6. Press
weighing mode.

7. Operation

7-1 Weighing

Begin with no load on the scale, the display reading zero. Place item(s) to be weighed on the
scale. The display shown is 1000.0g, gross weight.（The desired weighing unit should be
selected before weighing, refer to section 7-5.）
→
TARE
while powering on. Do not release it till the window displays
/MR
or
"appears at the left bottom.
"appears at the left bottom.
to save. After the window displays "
(II)
ZERO/ESC
TARE
to start zero point calibration.
TARE/
to move leftwards or rightwards.
to change the value. Press
JWL
to return to normal
"
"appears at the left bottom.
M-/SET
to enter the
M+/SAVE
to save.
TARE
to complete
", it will return to normal
"is
9