Voip Functionality; Registering; Placing A Call; Anonymous Call - NetComm NL1901ACV User Manual

O P T I O N
SIP Log Server IP Address Enter the Log Server IP address where the SIP Log data for the
SIP Log Server port
Ingress Gain
Egress Gain

VoIP Functionality

This section describes how to use the VoIP function of the DSL gateway in more detail. Some features involve 2 or 3
parties. In those cases, note that all 3 parties have to be successfully registered.

Registering

Before using any VoIP functions, the DSL gateway has to register itself to a registrar.
The DSL gateway also has to be configured with a proxy, which relays VoIP signalling to the next hop. In fact, many
implementations integrate these two into one server, so in many case registrar and proxy refer to the same IP.
1
Select the right interface to use for registering, depending on where proxy/registrar resides. If using a WAN
link, ensure that it is already up.
2
Select  Use SIP Registrar, and fill in the IP address and port with the correct value.
3
Fill the extension information: Authentication name, Password, Cid Name and Cid Number.
4
Click Apply to take the settings into effect.
5
TEL indicator of VoIP service should be on, indicating that SIP client is successfully registered.

Placing a Call

This section describes how to place a basic VoIP call.
1
Pick up the receiver on the phone.
2
Hear the dial-tone. Dial the extension of remote party.
3
To end the dialling, wait for digit timeout, or just press # immediately.
4
After the remote party answers the call, you are in voice connection.

Anonymous call

Anonymous call does not send the caller ID to the remote party. This is useful if you do not want others know who
you are. Check with your VoIP Provider if your service supports hidden caller ID.
1
Enable Anonymous calling in the Voice--SIP Advanced Setting page.
2
Pick up the receiver on the phone.
3
Dial *67 to enable anonymous call.
4
Hook on the receiver, and dial another extension as you like. Now your caller ID information is blocked.
NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
UG01063 v. 1.0 December 2018
gateway will be sent to.
Enter the port to be used for transmitting the SIP Log data.
Setting allow control of Speaker volume on handset.
Settings allow control of Microphone volume on handset.
Table 42 – SIP Debug Settings table
D E F I N I T I O N
104 of 146
© NetComm Wireless 2018