NetComm NL1901ACV User Manual page 114

I T E M
Log
Log Level
Display Level
Mode
Server IP Address For Remote or Both modes (see previous item) enter the IP Address of
Server UDP Port
Apply/Save
button
NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
UG01063 v. 1.0 December 2018
Select  Disable to turn off all system logging.
Select  Enable to begin logging according to the settings made on
this page.
This setting controls the types and amount of data
that is saved to the log file.
The event types listed at right are listed in
increasing (bottom to top) levels of importance.
Select a level to log that type of event and all types
of events above that level.
This setting controls the types and amount of data
that is displayed when the View System Log button
is pressed, see next section.
The event type display filter is exactly the same as
the Log Level event type controls: Select a level to
display that type of event and all types of events
above that level. The event types are listed in
increasing levels of importance
This setting determines where the log file, defined in Log Level, is
saved to:
Local – Saves the log data locally in the internal memory of the
Nl1901ACV gateway.
Remote – Exports the log data to a remote syslog server, e.g. for
remote monitoring/systems analysis, etc..
Both – Retains the data both locally and on a remote syslog server.
the remote syslog server that the data will be sent to.
For Remote or Both modes (see Mode item, above) enter the UDP Port
that will be used to transmit the data to the remote syslog server.
Click to generate a log according to the Log and Display Level settings
and save or send it to the destination selected in the Mode drop down
list.
D E S C R I P T I O N
• Emergency
• Alert
• Critical
• Error
• Warning
• Notice
• Informational
• Debugging
114 of 146
© NetComm Wireless 2018