Lan Vlan Setting; Figure 53 - Specify A Lan Port For Vlan Tagging; Table 20 - Ipv6 Lan Auto Configuration Settings - NetComm NL1901ACV User Manual

O P T I O N
Stateless
(for DHCPv6 Server)
Stateful
(for DHCPv6 Server)
Enable MLD Snooping
Enable Relay

LAN VLAN Setting

This page allows you to specify a LAN port to apply VLAN tagging to.
Select the LAN port using the drop down menu, then click the Add button.
Enter the VLAN ID and in the Pbits field enter a value from 0-7 indicating the priority of the VLAN.
Click Apply/Save when you have finished.
NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
UG01063 v. 1.0 December 2018
radvd periodically broadcasts RA packets to the attached link to
update network hosts. The gateway advertisement messages
contain the routing prefix used on the link, the link maximum
transmission unit (MTU), and the address of the responsible
default gateway.
IPv6 hosts can configure themselves automatically when
connected to a routed IPv6 network using Internet Control
Message Protocol version 6 (ICMPv6) gateway discovery
messages.
This type of configuration is suitable for small organizations and
individuals. It allows each host to determine its address from the
contents of received user advertisements. It makes use of the
IEEE EUI-64 standard to define the network ID portion of the
address.
This configuration requires some human intervention as it makes
use of the Dynamic Host Configuration Protocol for IPv6
(DHCPv6) for installation and administration of nodes over a
network.
The DHCPv6 server maintains a list of nodes and the information
about their state to know the availability of each IP address from
the range specified by the network administrator.
Select whether to enable or disable MLD Snooping on the
gateway. The Multicast Listener Discovery (MLD) snooping
function constrains the flooding of IPv6 multicast traffic on LANs
on the gateway.
When enabled, relays DHCP messages between DHCPv6 clients
and DHCPv6 servers on different IPv6 networks.
Table 20 – IPv6 LAN Auto Configuration settings
Figure 52 – Specify a LAN port for VLAN tagging
D E F I N I T I O N
54 of 146
© NetComm Wireless 2018