Management - Tr-069 Client - NetComm NL1901ACV User Manual

Management – TR-069 Client
TR-069 enables provisioning, auto-configuration or diagnostics to be automatically performed on your gateway if
supported by your Internet Service Provider (ISP).
By default it is turned off. Go to Management > TR-069 Client and select  Enable WAN Manage Protocol (TR-
069) to enable this service.
Once enabled, the following fields are available.
F I E L D
Inform
Inform interval
ACS URL
ACS User Name
ACS Password
WAN Interface used by
TR-069 Client
Display SOAP messages
on serial console
Connection Request
Authentication
Connection Request
Username
NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
UG01063 v. 1.0 December 2018
Figure 131 – Management – Enable TR-069 Client
Select  Enable for the TR-069 client to inform session
initialisation of the Auto-Configuration Server (ACS).
Time in seconds that inform session data is sent to the Auto-
Configuration Server (ACS). The interval can be up to
approximately one year – 32,000,000 seconds.
The address where the ACS server is located.
The user name to access the ACS server.
The password to access the ACS server.
The interface connection used to send and receive data to the
ACS server.
Use for troubleshooting via SSH or Telnet.
Select  Connection Request Authentication to add the
security of a username and password and identify the URL of
the connecting device.
When this is selected the following three fields are enabled:
Specify the Username required to be entered in order to make
a TR-069 connection.
D E S C R I P T I O N
118 of 146
© NetComm Wireless 2018