Table 23 - Outgoing Ip Filter Settings Table - NetComm NL1901ACV User Manual

P A R A M E T E R
Filter Name
IP Version
Protocol
Source IP Address/
Subnet Mask
Source Port
Destination IP
Address/Subnet
Mask
Destination Port
Click Apply/Save to take effect the settings. The new rule will then be displayed in the Outgoing IP Filtering table
list.
Incoming IP Filtering
By default, when NAT is enabled, all incoming IP traffic from WAN is blocked except for responses to requests
from the LAN. However, some specific incoming traffic from the Internet can be accepted by setting up Incoming
IP Filtering rules.
To delete the rule, click  in the Remove column next to the selected rule and click the Remove button.
To create a new incoming IP filter, click Add. The Add IP Filter-Incoming page will be displayed.
Enter the following parameters:
P A R A M E T E R
Filter Name
IP Version
NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
UG01063 v. 1.0 December 2018
Enter a name to identify the filtering rule.
Select the IP version to apply the filter to. (IPv4/IPv6)
Select the protocol type to block (UDP/TCP/Both)
Enter the IP Address of the host on the LAN to block
Enter the port number used by the application to block
Enter the IP Address of the Remote Server/host to which connections
should be blocked
Enter the destination port number used by the application to block
Table 23 – Outgoing IP Filter settings table
Figure 62 – Incoming IP Filter settings
Enter a name to identify the filtering rule
Select the IP version to apply the filter to
D E F I N I T I O N
D E F I N I T I O N
60 of 146
© NetComm Wireless 2018