Rip; Table 28 - Routing - Policy Route Settings Table; Table 29 - Routing - Rip Settings - NetComm NL1901ACV User Manual

Enter the details into the provided fields. The table below describes each field.
F I E L D
Policy Name
Physical LAN Port
Source IP
Use Interface
Default Gateway

RIP

The Routing Information Protocol (RIP) allows gateways to exchange network topology information. This
information allows the automatic creation and updating of routing tables.
Attention – RIP cannot be selected for a WAN interface which is NAT enabled, such as PPPoE.
Go to Basic Setup and select Ethernet WAN, click Next and then select IP over Ethernet (IPoE). The RIP option will now be
available.
I T E M
Interface
Version
Operation
Enabled
Apply/Save button
NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
UG01063 v. 1.0 December 2018
A user defined name for the policy route.
The LAN port to be used for the policy.
The IP address of the LAN device involved with the policy.
Select the Interface that the policy will employ.
Enter the gateway address.
Table 28 – Routing – Policy Route settings table
Figure 82 – Routing – RIP list
The network interface that the RIP settings apply to.
1 – Use RIPv1 to support classful routing.
2 – Use RIPv2 to support subnet information gathering and Classless
Inter-Domain Routing.
Both – RIP will use both RIPv1 & RIPv2, and will multicast and
broadcast to all adjacent gateways.
Passive – RIP will only respond to "Request Message" queries on the
RIP enabled interface.
Active – RIP will broadcast and respond to "Request Message"
queries on the RIP enabled interface.
Select  Enabled to activate the RIP routing service on the selected
Interface.
Click the Apply/Save button to initiate the change.
Table 29 – Routing – RIP settings
D E S C R I P T I O N
D E S C R I P T I O N
71 of 146
© NetComm Wireless 2018