Functions, Codes And Symbols - ABB REF615 Operation Manual

1MRS756708 A
1.4.3
615 series
Operation Manual
• LHMI messages are shown in Courier font, for example:
To save the changes in non-volatile memory, select Yes and press
• Parameter names are shown in italics, for example:
The function can be enabled and disabled with the Operation setting.
• Parameter values are indicated with quotation marks, for example:
The corresponding parameter values are "On" and "Off".
• IED input/output messages and monitored data names are shown in Courier font,
for example:
When the function starts, the START output is set to TRUE.

Functions, codes and symbols

All available functions are listed in the table. All of these may not be applicable to
all products.
Table 1: Functions included in standard configurations
Function
Three-phase non-directional
overcurrent protection
Three-phase directional overcurrent,
low stage
Three-phase directional overcurrent,
high stage
Arc protection
Non-directional earth-fault protection
Directional earth-fault protection
Transient/Intermittent earth-fault
protection
Non-directional (cross-country) earth
fault, using calculated I
0
Negative-sequence overcurrent
protection
Phase discontinuity
Table continues on next page
IEC 61850 IEC 60617
PHLPTOC1 3I>
PHHPTOC1 3I>> (1)
PHHPTOC2 3I>> (2)
PHIPTOC1 3I>>>
DPHLPDOC1 3I> → (1)
DPHLPDOC2 3I> → (2)
DPHHPDOC1 3I>> →
ARCSARC1 ARC (1)
ARCSARC2 ARC (2)
ARCSARC3 ARC (3)
EFLPTOC1 I > (1)
0
EFLPTOC2 I > (2)
0
EFHPTOC1 I >>
0
EFIPTOC1 I >>>
0
DEFLPDEF1 I > → (1)
0
DEFLPDEF2 I > → (2)
0
DEFHPDEF1 I >> →
0
INTRPTEF1 I > → IEF
0
EFHPTOC1 I >>
0
NSPTOC1 I > (1)
2
NSPTOC2 I > (2)
2
PDNSPTOC1 I /I1>
2
Section 1
Introduction
.
IEC-ANSI
51P-1
51P-2 (1)
51P-2 (2)
50P/51P
67-1 (1)
67-1 (2)
67-2
50L/50NL (1)
50L/50NL (2)
50L/50NL (3)
51N-1 (1)
51N-1 (2)
51N-2
50N/51N
67N-1 (1)
67N-1 (2)
67N-2
67NIEF
51N-2
46 (1)
46 (2)
46PD
11