Troubleshooting Processors; Troubleshooting The System Board - Dell PowerEdge M630 Owner's Manual

5. Ifthe Internal SDCard Redundancy option in the Integrated Devices screen of the System Setup is set to Mirror mode and
SD card 2 has failed, insert the new SD card into SD card slot 2.
6. IftheInternalSDCardRedundancyoptionin IntegratedDevicesscreenofthe System Setupissetto Disabled,replacethe
failed SD card withanew SD card.
7.
Install the blade in the enclosure.
8. Enter the System Setup and ensure that the InternalSDCardPortoption is enabled and InternalSDCardRedundancyoption
is set to Mirror mode.
9.
Check if the SD cardis functioning properly.
If the problem persists, see the Getting help section.
Related links
Getting help
Removing a hard drive or SSD
Removing the blade
Installing a blade

Troubleshooting Processors

1.
Remove the blade from the enclosure.
2.
Open the blade.
3.
Make sure that the processor(s) and heat sink(s) are properly installed.
4.
If the system only has one processor installed, make sure that it isinstalledintheprimaryprocessorsocket(CPU1).
5.
Close theblade.
6.
Install the blade in the enclosure.
7.
Run the appropriate diagnostic test.
Related links
Getting help
Removing the blade
Installing a blade

Troubleshooting the system board

Prerequisite
CAUTION: Many repairs may only be done by a certified service technician. Youshould only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with yourproduct.
Steps
1.
Remove the blade from the enclosure.
2.
Open the blade.
3.
Clear the blade NVRAM.
4.
If there is astill a problem with theblade, remove and reinstall the blade in the enclosure.
5.
Turnon the blade.
6.
Run the appropriate diagnostic test. For more information, see the Using system diagnostics section.
If the tests fail, see the Getting help section.
124