Dell PowerEdge M630 Owner's Manual page 86

Figure 37. Applying thermal grease on the top of the processor
1. processor
3. thermal-grease syringe
NOTE: The thermal-grease is intended for one-time use only. Dispose of the syringe after you use it.
c. Place the heat sink onto the processor.
d. Tighten the four screws to secure the heat sink to the system board.
NOTE: Tighten the screws diagonally opposite to each other. Do not over-tighten the heat sink retention screws
wheninstallingtheheatsink. Topreventover-tightening, tightentheretentionscrewuntilresistanceisfelt, and
stop after the screw is seated. The screw tension should be no more than 6 in-lb (6.9 kg-cm).
Next steps
1. Install the cooling shroud.
2. Followthe procedure listed inthe After working inside your system section.
As the system boots, it detects the presence of the new processor and automatically changes the system configuration
information in the System Setup.
3. Press F2 to enter the System Setup and check that the processor information matches the new system configuration.
4. Run the system diagnostics to verify that the newprocessor operates correctly.
5. Update the system BIOS.
86
2. thermal grease