Dell PowerEdge M630 Owner's Manual page 114

NOTE: PCIe extender or storage controller card is supported on systems with the SAS backplanes.
NOTE: You must remove the PCIe extender or storage controller card to replace a faulty PCIe extender or storage
controllercardorserviceothercomponentsinsidethesystem.
1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Remove the PCIe extender or storage controller card.
Steps
1.
Align the slots on the PCIe extender or storage controller card edge with the tabs on the support bracket.
CAUTION: Toprevent damage to the PCIe extender or storage controller card, you must hold the card only by its
edges.
2.
Lower the PCIe extender or storage controller card on to the connector on the system board.
3.
Tighten the two retention screws on the hard drive or SSD backplane cable connector to secure the card on to the system
board.
Figure 64. Installing the PCIe extender or storage controller card
1. retention screw (2)
3. tab on the PCIe extender or storage controller card
support bracket
Next steps
1. Install the following:
a. Hard drives or SSDs
b. Hard drive or SSD backplane
c. Hard drive or SSD cage
114
2. slot on the PCIe extender orstorage controller card
4. standoff (2)